Hi,
I am here to ask your help to understand if replacing the only internal unit from the Atea Nov903 to the Cyfral Smart 5p is possible.
The Atea is connected in the following way:
I have measured that there is:
Black/white: 12VAC
Black/red: 12VAC
Red/white: 0V
Blue/green: 6VDC
Blue/yellow: 6VDC
Blue/brown: 0VDC
This is the manual for the new unit:
I have set the unit to work as a 6-wires intercom. My idea is to wire in this way:
Call: previous 5 (brown)
Speaker: previous 1 (yellow)
Mic.: previous 2 (green)
Lock release: previous 7 (white)
Lock release ground: previous 8 (black)
Where I am not sure is what to do with the two previous commons (blue and red) that are 6VDC and 12VAC.
Any ideas?
Thanks
PS: sorry for the english message
I am here to ask your help to understand if replacing the only internal unit from the Atea Nov903 to the Cyfral Smart 5p is possible.
The Atea is connected in the following way:
I have measured that there is:
Black/white: 12VAC
Black/red: 12VAC
Red/white: 0V
Blue/green: 6VDC
Blue/yellow: 6VDC
Blue/brown: 0VDC
This is the manual for the new unit:
I have set the unit to work as a 6-wires intercom. My idea is to wire in this way:
Call: previous 5 (brown)
Speaker: previous 1 (yellow)
Mic.: previous 2 (green)
Lock release: previous 7 (white)
Lock release ground: previous 8 (black)
Where I am not sure is what to do with the two previous commons (blue and red) that are 6VDC and 12VAC.
Any ideas?
Thanks
PS: sorry for the english message
